Executive G-Code in reverse direction.

Dear All

can any one tell me how to executive g-code in reverse direction using motion adaptive feed. I am making WEDM in house and i want to control feed rate using this one.

i have a question with motion adaptive feed control:-
as per my knowledge motion adaptive feed is flot value and i can control it using a analog valueand its limit is 0 to 1 only but if i give negative analog value(-1) what happens????.... Will it executive g-code in reverse direction. pls help me to figure out this problem. it will helpful to me

if there is any misunderstanding pls let me know.

thanks ®ards
Parth Jetani

There is an experimental branch that allows for negative adaptive feed

github.com/LinuxCNC/linuxcnc/tree/feature/reverse-run-master2

(you replied to my video.)

Dear

first of all thanks to respond but i am facing some problem with above files.

i downloaded above file and try to follow install process but when i executive "make" command i found below error

Makefile:71: Makefile.inc: No such file or directory
Makefile:82: *** Makefile.inc must specify RTPREFIX and other variables. Stop.

i already search on Internet to rectified this problem but it is worth. no one give right solution
pls help me to figure out this problem.

thanks & regards
Parth Jetani

I think it sounds like you either missed out the ./configure stage or failed to define a --with-realtime= parameter that matches your realtime kernel.

thanks Andy,

but first of all i ran ./configure file after that i ran "make" command but it is showing same error. i followed a process which is given in "install" file. but still facing same error.
can you guide me how to solve this problems.

thanks & regards,
Parth Jetani

Do you have a realtime kernel?
What does "git branch" say? Also "uname -a"